NivelPro Reusable Tile Leveling Spacers, 50-Piece Alignment Kit

Fit tile after tile without ending up with an uneven, lippy floor. The NivelPro reusable tile leveling spacers are a T-pin-and-clip system built to hold two tiles at exactly the same height while the adhesive sets underneath. Fifty spacers and a dedicated wrench come in the pack, sized to work across tile thickness from 3mm to 25mm (about 0.1" to 1") and joint gaps of 2mm (0.08") or more, so the same set covers most standard floor and wall jobs.

Key features

• Reusable, not disposable — loosen the adjusting cover with the included wrench and the spacer comes free to use again on the next job.
• Keeps tiles from shifting while the adhesive cures — the T-pin locks two tiles at the same plane so nothing settles unevenly overnight.
• Works on floors and walls — the same clip handles horizontal and vertical tile runs, across a 3mm–25mm (0.1"–1") thickness range.

How it works

• Lay the first tile with at least a 2mm (0.08") seam, then set the second tile alongside it.
• Slide the T-pin into the seam and give it a quarter turn to lock it under both tiles.
• Turn the adjusting cover until the two tiles sit flush at the same level.
• Before the adhesive fully sets — typically within about 6 hours — back the adjusting cover off in the opposite direction.
• Give the T-pin another quarter turn so it lies flat against the tile, then lift the leveller away.
• Wipe the pieces down and store them dry, ready for the next job.

Specifications

Frequently asked questions

Can I reuse the spacers on more than one job?
Yes — once you loosen the adjusting cover with the wrench, each spacer lifts free clean and dry, ready to go again.

Will they work on wall tile as well as floor tile?
Yes, the same clip and T-pin system handles both horizontal floor runs and vertical wall installations.

What tile thickness does the kit support?
Anything from 3mm to 25mm (about 0.1" to 1"), with a minimum 2mm (0.08") joint gap.

How soon do I need to remove them?
Before the adhesive fully sets — usually within about 6 hours — back off the cover, release the T-pin, and lift the spacer away.

Every order ships free with no minimum, and you get 30 days to send it back if it's not the right fit for your job. Real human support is at Support@fioriscas.com.